![]() ![]() It is always strongly recommended to establish the MP-BGP session using the loopback interface.However, the service provider's NMS reports that this backup link is It is best to avoid using the debug command on a working router/switch. Configuring BGP on Cisco Routers (BGP) v4. On R2 and R3, use the command “show ip bgp summary” to confirm that the BGP sessions is established. Frequency (in seconds) with which the Cisco IOS software sends keepalive messages to its peer. How to check bgp timers on cisco router 31 a keepalive interval of ten seconds is used, and a hold time of 32 seconds.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |